News & Event

Before formally blowing and installing optical fibers, it is necessary to check the connectivity of microducts. This is done by blowing a Blowing Sponge—made of elastic material—into the microduct; if the Blowing Sponge ejects from the other end of the microduct, the route is in good condition. Aft

Horizontal directional drilling (HDD) is a construction machine used to lay various underground public facilities without excavating the ground, such as microducts and cables. Based on the problems encountered during underground crossing construction with HDD, this paper analyzes the causes of devia

Microduct connectors(also called microduct coupler) are designed to provide a secure and stable connection between two segments of Microducts and main conduit. Straight and Transition couplers are available. Multiple sizes available starting from 5 mm to 27mm.

Optical cable jetting also called “Fiber Cable Blowing” is a highly efficient method for laying underground optical cables. However, to ensure a smooth process, several preparations must be made before the actual cable jetting begins.

In the realm of underground fiber optic cable installation, the technique of fiber cable blowing has emerged as a highly efficient and cost-effective method, especially in urban environments where traditional trenching and cable laying can be both disruptive and expensive.

The pipe hole resources of underground communication pipelines are basic communication resources in short supply for operators. Except for newly built roads and roads in development zones, the occupancy rate of pipe holes on other roads is generally high.

The ratio of the outer diameter of the cable to the inner diameter of the duct should be close to 60%. With this value, the greatest blowing distance is achieved.

Rewinding a duct rodder properly is essential for its longevity and efficient use. Follow these steps to ensure you rewind your duct rodder correctly:Fiberglass Duct rodder1.Clear the Rod: Before rewinding, ensure the rod is free of any dirt, debris, or moisture.

In the world of fiber optic network installations, the process of deploying fiber cables plays a crucial role in determining the efficiency and reliability of the network. Traditionally, cable pulling has been the go-to method for installing fiber optic cables.