News & Event

Before formally blowing and installing optical fibers, it is necessary to check the connectivity of microducts. This is done by blowing a Blowing Sponge—made of elastic material—into the microduct; if the Blowing Sponge ejects from the other end of the microduct, the route is in good condition. Aft

During the process of optical cable air blowing construction, there are many factors that will affect the smooth progress of optical cable air blowing. Including HDPE microduct and air blowing cable condition etc.

Fiber cable blowing technology is a popular optical cable laying technology. The high-pressure and high-speed airflow generated by the air compressor and the microduct conduit or air blowing fiber are sent into the pre-layed silicone tube through cable jetting machine. Silicone tube protection can greatly reduce the friction coefficient between optical cables and conduits, greatly increase the length of a single laying. However, encountering blockages during this process is a common challenge that needs to be handled promptly and efficiently.

The pipe hole resources of underground communication pipelines are basic communication resources in short supply for operators. Except for newly built roads and roads in development zones, the occupancy rate of pipe holes on other roads is generally high.

Have you encountered the following problems during fiber cable blowing? 1.Outer protection tube blocked. 2.HDPE fiber optic conduit can't blow. 3.The air blowing distance of the micro duct is not enough. 4.Air blown fibre microduct blowing speed is slow. 5.Micro conduit damaged during laying. 6.Underground micro cable can't blow. 7.Micro cable blowing distance is not enough.

The ratio of the outer diameter of the cable to the inner diameter of the duct should be close to 60%. With this value, the greatest blowing distance is achieved.

FCST will participate in CIOE 2023/ECOC 2023/Cairo ICT 2023.Welcome to our booth to explore product solutions and feature applications. We will also perform a live demo of our Cable Jetting Solution, showing real-life installation scenarios for FTTH.

Rewinding a duct rodder properly is essential for its longevity and efficient use. Follow these steps to ensure you rewind your duct rodder correctly:Fiberglass Duct rodder1.Clear the Rod: Before rewinding, ensure the rod is free of any dirt, debris, or moisture.

In the world of fiber optic network installations, the process of deploying fiber cables plays a crucial role in determining the efficiency and reliability of the network. Traditionally, cable pulling has been the go-to method for installing fiber optic cables.