News & Event

Before formally blowing and installing optical fibers, it is necessary to check the connectivity of microducts. This is done by blowing a Blowing Sponge—made of elastic material—into the microduct; if the Blowing Sponge ejects from the other end of the microduct, the route is in good condition. Aft

Fiber cable blowing is a safe and effective optical cable laying method. During the cable laying process of the cable blowing machine, the traction force of the dragger, the blowing force of the compressed air and the thrust of the conveyor belt act on the optical cable at the same time.

The cable jetting solution for laying optical cables uses air pressure blowing to blow the optical cable into the laid HDPE conduit pipe. The cable blowing method for laying optical cables is widely used. We may encounter some emergency problems when we carry out cable blowing construction, so how should we respond in time? Here are seven emergency treatment methods for blowing cable construction.

Approximate Volume Of Lubrication Required For Cable Jetting In Various Size Microducts With the popularization of the Underground Cable Installation Solution, the construction of the basic network architecture has been accelerated. But there will be some problems during construction. For example, t